SET COIN SPECS
--USE BATCH KEY
DISABLED
COIN 3 VALUE
COIN TYPE
COIN 3 VALUE
13. PROGRAM COIN VALUES.
A. Turn Keyswitch to vertical position, hold
Batch Key on Control down, and switch
the Sorter Power Switch (see
FIGURE #7) to ON.
B. Cycle MOTOR ON / OFF Key until
Display shows:
C. Cycle BATCH Key to display the station
to be changed. The existing information
for that coin will be displayed. Refer to
FIGURE #10 for coin locations.
D. If you wish to change the existing coin
value, proceed to Step "E". If the coin is
to be disabled (no count), programmed
for a token count (unit count -- does not
add to totals), or changed to a coin type
(denomination value -- adds to total),
E. Cycle the ACCEPT Key until the Display
required is shown.
UNIT TOKEN TYPE
OR
TOKEN
OR
COIN 3 VALUE
Programming
coin values
COIN 3 VALUE
W / VALUE
57