Table of Contents
Advertisement
Programming
default settings
The Sorter is set when manufactured to the following default parameters. Each of the parameters may
be changed to fit your specific application. Refer to the following section for these instructions. To enter
the Programming Mode: 1) turn Keyswitch to vertical, 2) hold Batch Key down at power--up.
Press the "MOTOR ON / OFF " Key to cycle through the programming mode, following the instructions
to change the default settings. Once completed, press "BATCH" Key and then turn the Keyswitch to
horizontal.
IF
AN
ERROR
PROGRAMMING, AND THE DISPLAY
APPEARS
TO
PREVENTING
ADDITIONAL
SWITCH THE MAIN POWER SWITCH TO
"OFF"
TO COMPLETELY
PORGRAMMING MODE.
SWITCH
THE
POWER
RE--ENTER THE PROGRAMMING MODE
AND CONTINUE OPERATION.
Note: If display = yes is initialized, the
information will be sent to Port #4. Connect
the Remote Batch Display to this port.
Note: If print = yes is initialized, the
information will be sent to Port #3. Connect
the Remote Printer to this port.
28
IS
MADE
DURING
BE
"LOCKED--UP"
ENTRIES,
EXIT
THE
BACK
ON,
DEFAULT SETTINGS
Note: The settings described here are
standard defaults. Settings for specific
countries or applications may be diifferent,
and are selectable by the operator.
If the display shows a RAM--ROM condition,
the Sorter will revert to these standard
values.
1. SET TIME AND DATE
Default = Day / Month / Year
2. DISPLAY DECIMAL POINT / COMMA
(CHOICE AND LOCATION)
Default = Decimal point in position .00
3. SET FEE PERCENT
Maximum is 9.99%
4. SET FIXED FEE
Maximum is 19.99
5. BATCH PRINT LENGTH / NUMBER OF
COPIES
Default = Long printout with 1 copy
6. GRAND PRINT LENGTH / NUMBER OF
COPIES
Default = Long printout with 1 copy
7. RS232 COMMUNICATION PORT
PARAMETERS
Port #1 Default =
9600 Baud / No Parity / 7 Data Bits / 1
/ DTE / No Handshaking / No ACK NAK
Port #2 Default =
Same as Port #1
Port #3 Default =
Same as Port #1
Port #4 Default =
Same as Port #1
Hide quick links:
Advertisement
Table of Contents
