Accepting Quantities / Totals - De La Rue MACH 6 User Manual

accepting quantities and / or totals
Note: Each time a Batch, or Grand total is
accepted an audit trail will print if the printer
option is utilized.
1. Batch ACCEPT
With the Display in the BATCH TOTAL
mode, press the ACCEPT Key once. The
BATCH TOTAL is cleared, and the Control
remains in the BATCH mode. The BATCH
TOTAL is added to the GRAND TOTAL.
2. Grand ACCEPT (All Grand Totals remain)
With the Display in the GRAND TOTAL
mode, press the ACCEPT Key once. The
GRAND TOTAL remains on the Display. To
clear the Display, refer to "Clearing
Quantities and / or Totals" on the following
pages. The GRAND TOTAL can be
accepted only if the BATCH TOTAL is zero.
Note: The Printer must be allowed to finish
the print cycle before attempting to accept a
coin total or an operator message will
appear. Refer to "Operator Messages" later
in this Guide for additional information.
Note: If a batch or grand total is accepted
and the Printer is off--line (sel light "off"), the
tape will not advance far enough for proper
tear--off. Turn the Printer Power Switch off,
wait a few seconds, then on again. Press
the "sel" key and continue operation.
Operation
17