Check For Shipping Damage; Check For Missing Parts; Secure The Sorter - De La Rue MACH 6 User Manual

Introduction
installation
(2)
1/4" / 6.35MM
HOLES
1-5/8" / 41.3MM
FIGURE #3
COUNTERTOP INSTALLATION
FIGURE #4
STAND INSTALLATION
6

CHECK FOR SHIPPING DAMAGE

The Sorter and all options were thoroughly
tested after they were manufactured and
carefully packaged when they left the factory.
ANY DAMAGE THAT MAY HAVE BEEN
DONE IN SHIPMENT SHOULD BE
REPORTED TO THE CARRIER
IMMEDIATELY, AND THE SHIPPING
CARTON(S) AND PACKAGING RETAINED
FOR INSPECTION, IF NECESSARY.
15-1/8" / 384.2MM

CHECK FOR MISSING PARTS

Compare the items received against the original
order. Notify your Authorized Sales / Service
1" / 39.4MM
Representative of any discrepancies.

SECURE THE SORTER

(IF DESIRED)
The Sorter will sit on a countertop or tabletop. It
may be attached for security. A drilling guide is
shown in FIGURE #3.
If bagging coin is desired, the Sorter must be
attached to its own stand as shown in
FIGURE #4.
Note: The distance from the front edge of
the countertop to the Sorter to be
determined at installation. Allow sufficient
clearance at the rear and right side of the
Sorter to allow the Inspection Pan room to
move freely throughout its travel range.
Screw length should be 3/4" (maximum) plus
the thickness of the countertop.
Note: A Security Stand, utilizing a sliding
drawer configuration to protect the coins is
also available.
Contact your Authorized Sales
Representative for additional information.