Assembling The Tool Holder; Inserting Tool Holder(Same As Hr4000C) - Makita HR5001C Technical Information

Assembling the tool holder

a. Set the parts described below into the crank housing.(See the figure 20.)
b. To set the spiral bevel gear 41, use the tool holder wit h out mounting the lock sleeve for smooth setting.(See the figure 21.)
•Striker(mounted with O ring 34)
•Washer 45
•Ring 45
•Flanged sleeve 22
•Ring 22
•Spiral bevel gear 41
•Compression spring 46
•Slide sleeve
•Rubber ring
Note ) Use care that the washer 45, Flanged sleeve 22, rubber ring 24, ring 22 and striker have each direction.
Rubber ring
Flanged sleeve
Ring 22

Inserting Tool holder(Same as HR4000C)

a. Assemble Tool holder B and Spiral bevel gear 41,
matching the cams of both parts.(See the figure 23.)
b. Turn Spiral bevel gear 41 to match dent portions on the can
with grooves on Crank housing. (see the figure 22.)
c. Match the cam on Lock sleeve A to the cam on Tool holder B.
(see the figure 23)
d. Match the flat portion of Lock sleeve A to the mounting side of Change
lever. fit the 6 protruded portions on Lock sleeve B to the 6 grooves on
Crank housing, and then insert the tool holder into Crank housing.
(see the figurt 23.)
Tool holderA
Compression
Slide sleeve
spring 46
Ring 45
Figure 20
Cam on the lock sleeve A
6 protruded portions
on the lock sleeve B
Figure 23
Spiral bevel
gear 41
Striker
O ring 34
Washer 45
Use care of each direction.
12 dent portions
on the cam of the
spiral bevel gear 41
Cam on the tool holder B
Cam on the spiral
bevel gear 41
Flat portion of lock sleeve B
Crank housing
Spiral bevel gear 41
Tool holder
Figure 21
6 grooves on the
crank housing
Mounting side
of the change
lever
Figure 22