Lubrication; O Ring Of Striker; Outer Surface Of Impact Bolt; Lip Of Oil Seal 14 And Oil Seal 48 - Makita HR5001C Technical Information

Lubication
To prevent abrasion and overheating, please apply the
MAKITA grease R No.00 at the positions shown below.
a. O ring of striker
b. Inside of ring 45
c. Inner of slide sleeve
d. Outside and gear of Spiral bevel gear 41
e. O ring of piston and rod hole
f. Outer surface of impact bolt
Outer surface
of impact bolt
g. Between spiral bevel gear 12 and the torque limiter complete
Between Spiral
bevel gear 12 and
torque limiter complete
h. Lip of Oil seal 14 and oil seal 48
i. Needle bearing(Gear housing, Helical gear 20 complete)
Needle bearing
j. Each gear teeth
Inside of
Inside of
slide sleeve
ring 45
O ring
Lip
Gear housing
Spiral bevel
gear 41
O ring
Outside
Striker
Rod hole
Needle bearing
Helical gear 20 complete
Teeth