Repair - Makita HR5001C Technical Information

Repair

(1) Removing Change lever ------------------------------ ------(Page 6 of 14)
(2) Install Change lever ------------------------------- ----------(Page 6 of 14)
(3) Replace the Armature ------------------------------- --------(Page 7 of 14)
(4) Disassembling the chuck --------------------------- -------(Page 8 of 14)
(5) Assembling the chuck ------------------------------- -------(Page 8 of 14)
(6) Removing Tool holderers --------------------------- ------(Page 8 of 14)
(7) Disassembling tool holders ------------------------- -------(Page 9 of 14)
(8) Assembling the tool holder A and B ----------------- -----(Page 9 of 14)
(9) Taking out Cylinder 40 ----------------------------- --------(Page 9 of 14)
(10) Assembling Piston, Rod and Crank shaft -------------- -(Page 10 of 14)
(11) Assembling Fluoride ring 28 on Impact bolt ---------- (Page 10 of 14)
(12) Assembling several parts in Crank housing ----------- (Page 11 of 14)
(13) Inserting T ool holders -------------------------------------(Page 11 of 14)
(14) Assembling Torque limiter complete -------------------(Page 12 of 14)
(15) Lublication ----------------------------------------- --------(Page 13 of 14)