Yardworks 060-3864-2 Owner's Manual page 14

Operation and Adjustments
ADJUSTING THE DETHATCHER DEPTH (Fig. 6)
CAUTION: BEFORE YOU ADJUST THE DETHATCHER DEPTH, TURN OFF THE
POWER, UNPLUG THE TOOL AND ENSURE THE MOTOR HAS STOPPED.
1. The dethatcher depth is adjusted by turning the hubcaps. You can choose from
three different depth settings by pulling out and turning hubcaps.
2. When setting "I" is at the bottom, the high setting is locked in. The dethatcher
depth is approx 1 mm above the ground. Select depth setting "I" when transporting
the dethatcher.
3. When setting "II" is at the bottom, the middle setting is locked in. The dethatcher
depth is approx 1/8" (3 mm).
4. When setting "III" is at the bottom, the low setting is locked in. The dethatcher
depth is approx 3/8" (10 mm).
CAUTION: THE HUBCAPS MUST BE FIRMLY LOCKED INTO PLACE! AT THE
BEGINNING IT IS BEST TO SELECT DEPTH SETTING "I" AT THE START. YOU
CAN THEN SWITCH TO SETTING "II" WHEN THE DETHATCHER SPIKES HAVE
BECOME WORN.
Fig. 6
14