Emergency Starting - BRP Ski-doo Tundra Series Operator's Manual

4. Ensure that the tether cord cap is in-
stalled on the engine cut-off switch
and that the cord is attached to your
clothing eyelet.
5. Ensure that the emergency engine
stop switch is in the ON position
(UP).
6. Depress the START/RER button.
7. Release button immediately when
engine has started.
WARNING
Never depress throttle while start-
ing engine.
NOTICE
Do not engage electric
starter for more than 10 seconds at
a time. A rest period should be ob-
served between the cranking cycles
to allow electric starter to cool down.
8. Release parking brake.
NOTE: For an initial cold start, do not
release parking brake. Perform the
VEHICLE WARM-UP
plained below.

Emergency Starting

600 ACE and 550F Models
Do not attempt an emergency starting
procedure. Have the battery charged
or replaced.
600 HO E-TEC Model
The engine can be started with the
emergency starter rope supplied with
the tool kit.
Remove belt guard.
procedure as ex-
_______________
WARNING
Do not wind starting rope around
your hand. Hold rope by the han-
dle only. Do not start the snowmo-
bile by the drive pulley unless it is
a true emergency situation. Have
the snowmobile repaired as soon
as possible.
mmo2008-005-008_a
Attach one end of emergency rope to
rewind handle.
NOTE: The spark plug socket can be
used as an emergency handle.
mmo2008-005-007
Attach the other end of emergency
rope to the starter clip supplied in the
tool kit.
BASIC PROCEDURES
69