BRP Ski-doo Tundra Series Operator's Manual page 145

NOTE: Some of the listed pilot lamps do not apply to all models.
PILOT
LAMP(S) BEEPER
ON
4 short beeps
every 30
seconds
Short beeps
repeating
beeps every
5 minutes
4 short beeps
—
beeps every
5 minutes
—
beeps every
5 minutes
Short beeps
—
repeating
Engine is overheating, reduce snowmobile speed and run
in loose snow or stop engine immediately and let engine
cool down. Check coolant level, refer to
If coolant level is correct and overheating persists, contact
an authorized Ski-Doo dealer. Do not run the engine if
condition persists.
Reduce speed or stop engine. Let engine cool down and
restart. If overheating persists, contact an authorized
Ski-Doo dealer. Do not run the engine if condition persists.
Critical overheat. Stop engine immediately and let engine
cool down. Check coolant level, refer to
If coolant level is correct and overheating persists, contact
an authorized Ski-Doo dealer. Do not run the engine if
condition persists.
rapidly
Critical overheat. Stop engine immediately and let engine
cool down. If overheating persists, contact an authorized
Ski-Doo dealer. Do not run the engine if condition persists.
Do not run the engine if condition persists.
4 short
Indicate a low or high battery voltage condition. See an
authorized Ski-Doo dealer as soon as possible.
Engine fault, see an authorized Ski-Doo dealer as soon as
possible.
Engine detonation (RPM is limited when this condition
occurs).
4 short
– Ensure recommended fuel is used.
– Check fuel quality, replace if necessary.
– If fault still occurs, contact an authorized Ski-Doo dealer.
4 short
Engine RPM limited for protection when certain faults occur.
Shutdown procedure in force due to engine overheating or
fuel pump problem, remove tether cord cap from engine
rapidly cut-off switch and contact an authorized Ski-Doo dealer.
MONITORING SYSTEM (600 ACE AND 600 HO E-TEC)
DESCRIPTION
______________
MAINTENANCE
.
MAINTENANCE
.
143