BRP Ski-doo Tundra Series Operator's Manual page 104

MAINTENANCE PROCEDURES
Drive Belt Height Adjustment
The drive belt height must be checked
every time a new belt is installed.
To adjust the drive belt height, proceed
as follows:
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove drive belt guard, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
3. Loosen the clamping bolt.
mmo2011-003-010_a
1. Adjuster hub
2. Clamping bolt
4. Using the suspension adjustment
tool provided in the tool kit, turn the
ring 1/4 turn at a time then rotate the
driven pulley to properly set the belt
between the pulley sheaves.
mmo2011-003-011_a
1. Suspension adjustment tool
NOTE: The adjustment ring has left
hand treads.
______________
102
.
Repeat step 4 until the lowest portion
of the cogs on the external surface of
drive belt is even with the driven pulley
edge.
mmo2012-006-905_a
TYPICAL - PRELIMINARY SETTING
1. Lowest portion of cogs even with external
surface of drive belt
NOTE: Turning the ring counterclock-
wise lowers the belt in the pulley. Turn-
ing the ring clockwise raises the belt in
the pulley.
5. Firmly tighten the clamping bolt. If
possible, tighten to specification.
TORQUE
Clamping
bolt
mmo2012-004-903_a
TYPICAL
1. Clamping bolt
6. Install belt guard, refer to
TROLS, INSTRUMENTS
EQUIPMENT
7. Install side panel, refer to
TROLS, INSTRUMENTS
EQUIPMENT
5.5 N•m ± 0.5 N•m
(49 lbf•in ± 4 lbf•in)
.
.
CON-
AND
CON-
AND