CD130
Steering Wheel Turns Hard Or Jerky
Possible Cause
•
Low power steering pump fluid level
•
Drive belt loose or in poor condition
•
Insufficient lubrication on steering system
components
•
Insufficient lubrication on transom gimbal
housing assembly and swivel shaft
•
Loose or missing steering fasteners or parts
•
Contaminated power steering fluid
Power Trim Does Not Operate (Electric Motor Does Not Run)
Possible Cause
•
Blown Fuse
•
Loose or dirty electrical connections or dam-
aged wiring
Power Trim Does Not Operate (Electric Motor Runs But Drive Unit Does Not
Move)
Possible Cause
•
Pump oil level low
•
Drive unit binding in gimbal ring
118
•
Refill system with fluid.
•
Replace and/or adjust.
•
Lubricate.
•
Lubricate.
•
Check all parts and fasteners. If any are loose
or missing, see Authorized MerCruiser Dealer
immediately.
•
Drain and replace.
•
Replace fuse.
•
Check all associated electrical connections and
wires (especially battery cables). Clean and tight-
en faulty connection. Repair or replace wiring.
•
Fill pump with oil.
•
Check for obstruction.
Remedy
Remedy
Remedy