CD49
Remote Control Operates Hard, Binds, Has Excessive Free-play Or Makes
Unusual Sounds
Possible Cause
Insufficient lubrication on shift and throttle
linkage fasteners
Loose or missing shift and throttle linkage
fasteners
Obstruction in shift or throttle linkages
Shift or throttle cable kinked
Improper shift cable adjustment
Vacuum leak at shift cylinder, hose or fittings
of Power Shift Assembly, if so equipped
CD130
Steering Wheel Turns Hard Or Jerky
Possible Cause
Low power steering pump fluid level
Drive belt loose or in poor condition
Insufficient lubrication on steering system
components
Insufficient lubrication on transom gimbal
housing assembly and swivel shaft
Loose or missing steering fasteners or parts
Contaminated power steering fluid
Power Trim Does Not Operate (Electric Motor Does Not Run)
Possible Cause
Blown Fuse
Loose or dirty electrical connections or dam-
aged wiring
Power Trim Does Not Operate (Electric Motor Runs But Drive Unit Does Not
Move)
Possible Cause
Pump oil level low
Drive unit binding in gimbal ring
Troubleshooting
Lubricate.
Check all linkages. If any are loose or missing, see
Authorized MerCruiser Dealer immediately.
Remove obstruction.
Straighten cable, or have dealer replace
cable if damaged beyond repair.
See Authorized MerCruiser Dealer immedi-
ately for shift cable adjustment .
Repair cut, pinched, or kinked hose or faulty
shift cylinder.
Refill system with fluid.
Replace and/or adjust.
Lubricate.
Lubricate.
Check all parts and fasteners. If any are loose
or missing, see Authorized MerCruiser Dealer
immediately.
Drain and replace.
Replace fuse.
Check all associated electrical connections and
wires (especially battery cables). Clean and
tighten faulty connection. Repair or replace wir-
ing.
Fill pump with oil.
Check for obstruction.
Remedy
Remedy
Remedy
Remedy
53