Mercury D4.2L Manual page 47

CA627
POWER TRIM OPERATION - DUAL ENGINE CONSOLE MOUNT REMOTE CONTROL (TWO BUTTON
AND THREE BUTTON VERSIONS)
IMPORTANT: If TRAILER button is held depressed after drive unit reaches end of upward travel, an inter-
nal circuit breaker will open and pump will stop. Should this happen, release button and allow motor to
cool for about one minute. Circuit breaker will reset and Power Trim operation may be resumed.
When lowering or raising sterndrives equipped with a dual engine tie bar kit, the sterndrives must be
raised or lowered evenly to prevent the tie bar from becoming twisted. Failure to raise or lower
sterndrives evenly may result in tie bar or sterndrive damage.
1
Trailer Button (Both Versions) - Press button until drive unit reaches desired height for trailering drive units.
2
Two Button Trim Control (Dual Buttons in Handle) - used to control both drive units from the handle. Press
UP on button(s) to trim drive unit UP/OUT. Press down on button(s) to trim drive unit DOWN/IN.
A
Forward Trim Button - Used to trim the port drive unit.
B
Rear Trim Button - Used to trim the starboard drive unit.
3
Three Button Trim Control (Trim Adjustment Switches) - With a single integral trim button in the handle
to control two drive units simultaneously, these two switches control the fine tune adjustment of each drive unit.
Using these Fine Tune Switches, set each drive unit to the desired trim angle. Then use the single trim switch
in the handle to control the trim of both drive units simultaneously.
4
Three Button Trim Control (Single Trim Switch in Handle) - used to trim both drives simultaneously after
drives have been fine-tuned as described above.
CB193
POWER TRIM OPERATION - THREE BUTTON TRIM PANEL
(USED ON MODELS WITH TWO-LEVER CONTROL)
IMPORTANT: If TRAILER button is held depressed after drive unit reaches end of upward travel, an inter-
nal circuit breaker will open and pump will stop. Should this happen, release button(s) and allow motor
to cool for about one minute. Circuit breaker will reset and Power Trim operation may be resumed.
5
Trailer Position: Simultaneously press the UP button (top) along with the UP/OUT button (center) until drive
unit reaches desired trailer position.
6
Trim Drive Unit UP/OUT: Press center UP/OUT button until drive unit reaches desired trim position.
7
Trim Drive Unit IN/DOWN: Press IN button until drive unit reaches desired trim position.
CAUTION
47