Mercury D4.2L Manual page 45

CB188
POWER TRIM OPERATION - PANEL MOUNT REMOTE CONTROL
IMPORTANT: If TRAILER button is held depressed after drive unit reaches end of upward travel, an inter-
nal circuit breaker will open and pump will stop. Should this happen, release button and allow motor to
cool for about one minute. Circuit breaker will reset and Power Trim operation may be resumed.
1
Trailer Position: Press button until drive unit reaches desired height.
2
Trim UP/OUT: Press UP on Trim switch until drive unit reaches desired trim position.
3
Lower Drive Unit: Press DOWN on Trim switch until drive unit reaches desired position.
CB189
POWER TRIM OPERATION - CONSOLE MOUNT REMOTE CONTROL
(SINGLE ENGINE VERSION)
4
Trailer Position: Press button until drive unit reaches desired height.
5
Trim UP/OUT: Press UP on Trim switch until drive unit reaches desired trim position.
6
Lower Drive Unit: Press DOWN on Trim switch until drive unit reaches desired position.
45