Pager Learning - Vision TR537S User Manual

Before you can begin using your pager, you must first learn it to
the system. One pager is included with this system, but you can
learn up to 4 total. The learning procedure is given below.
IMPORTANT
All previously learned remotes will be deleted from memory. If you have
more than one remote, you must re-learn all of them.
1. Disarm, and turn on the Ignition.
2. Press-and-hold the Program Switch. The Status LED will light. Release
the switch only when the LED turns off and you hear 3 siren chirps (af-
ter about 6 seconds of pressing). Pager memory has now been wiped.
3. 1480: Press buttons
You should then hear 1 siren chirp, and the pager will beep 1 time.
4. If you have another pager, learn it now by pressing buttons
(1480), or button
you program a 3rd pager you will then hear 3 siren chips, and for a 4th
pager you will hear 4 siren chirps.
5. Switch off the Ignition. The Status LED will light for 6 seconds and
then turn off. The LED will then flash the same number of times as your
Manual Disarm Code (default = 6). Learning is finished.
If you delay more than 6 seconds after Steps 2 or 3 above, a timeout will
occur and you will need to start over from Step 1.
If at any time you mess up, perform Step 5, then start over from Step 1.
MULTIPLE PAGER OPERATION
When using more than one pager, only the pager that last communicated with
the 1480/1460 will receive an Answer-Back response from the 1480/1460.
MIXING PAGER MODELS
You cannot learn a TR537S (ARIB T-67) pager and a TR835S (FCC)
pager. All your pagers must be the same model.
© 2 0 1 1 - 2 0 1 6 K I R A M E K , I N C .
(1480: LED will flash if a door is open.)
& at the same time. 1460: Press button
(1460). You will then hear 2 siren chirps. And if
PAGER L EARNING
.
&
20