Table of Contents
Advertisement
NO CONFIRMATION CHIRP ARMING
This method is identical to "Normal
Arming" except there is no siren chirp-
ing after you Arm or Disarm. Ensure
that all doors are closed and then press
Button-III on the Pager remote. After you press But-
ton-III, the doors will lock and hazard lights will flash once (if supported).
The Pager Remote will beep once and update (see Fig-1), and Status LED
will light solid for 5 seconds. (The siren can't be triggered while the LED
is lit — See "Error Chirp" below.)
SENSOR BYPASS ARMING
This method allows you to disable the
shock sensor and any other external
sensor while keeping all other triggers
active (door, trunk, hood, IG).
Pager Buttons I & II at the same time, then release. The doors will lock and
hazard lights will flash once (if supported). The siren may chirp 2 times,
the Pager will beep once and update as shown in Fig-1 but also with the
icon, and the Status LED will light for 5 sec. NOTE: If you later short-press
the Pager's
button to update the LCD with the car's current status, the
icon will disappear but the 1480/1460 is still in Sensor Bypass mode.
Error Chirp
When you Arm, the siren chirps 1 time (if using Normal Arming with Con-
firmation Chirps enabled) and the Status LED lights for 5s. If any door,
or the trunk or hood is opened during the 5s and stays open, the siren will
chirp 2 more times ("Error Chirp"), your pager will also beep and update
icons, and that particular trigger will be bypassed. If the bypassed door or
hood or trunk is later closed, it will be re-enabled 5s later. (You will hear
the 2 Error Chirps even when Arming with Button-II or III.)
NOTE
Your 2-way pager will update its icons during an Error Chirp condition
to show the bypassed sector. However, the pager will not update if that
sector is later re-enabled. Press the
© 2 0 1 1 - 2 0 1 6 K I R A M E K , I N C .
System Operation
Press
button to update the pager status.
8 8
Advertisement
Table of Contents
