Ignition Trigger; Hood Trigger - Vision TR537S User Manual

AL ARM TRIGGERS

IGNITION TRIGGER

There are two different modes that pertain to Ignition triggers, as de-
scribed on page 7 of the 1480/1460 Owner's Guide. In either case, the pager
icon is the same when you switch on the Ignition while Armed, as shown in
Fig-8 below. But in IG Protect Mode, if the Ignition is switched on while
Armed, the pager will also emit a siren sound.
Note that if you Disarm, or if you are using Direct Door Lock, your pager
will not auto-update when you switch on the Ignition. However, if you
short-press the
then display the Exhaust icon.

HOOD TRIGGER

On compatible vehicles (or on any vehicle when the 1480's gray Hood input
wire is connected), the siren will blast for 30 seconds when the hood is
opened while Armed. The pager will also emit a siren sound. But whether
the pager will display a flashing Door icon and/or flashing Hood icon will
depend on the car and whether the optional gray Hood input wire is con-
nected. (See page 15 in the 1480 Owner's Guide for details.)
Assuming your car does not support Hood triggers via CAN, and assuming
the optional Gray input wire of the 1480 is connected, whenever the Hood
is opened while Armed, the pager will update as shown in Fig-9 below.
15
FIG-8: Pager LCD Icon Change Upon Ignition ON
button while the Ignition is switched on, the pager will
Pager Hood icon doesn't display with the 1460.
HOOD TRIGGER
FIG-9: Pager LCD Icon Change Upon Hood Trigger
"Exhaust" icon shows
the Ignition switched
ON while Armed. Icon
is the same for RSCM
or IG Protect Modes.
Trunk icon flashes on the 1460
HOOD
when using the WHT/BLK wire,
ICON
FLASHES
even if you connect it to Hood.
V I S I O N R F P A G I N G S Y S T E M U S E R ' S G U I D E