Installation - Vision TR537S User Manual

INSTAL L ATION
Main
Harness
Antenna Unit
The "CALL" button is non-functional.
MOUNTING STEPS
1) First locate the 1480/1460 Control Module, which is most likely installed
on the driver's side, behind the cover just above the brake and accelerator
pedals. Don't disconnect anything from the Control Module.
2) Connect the Antenna Unit's wire harness between the 1480/1460 Con-
trol Module and the Antenna Unit as shown above.
3) We recommend mounting the Antenna Unit in open view on the outside
of the driver's side A-pillar as shown above. Remove the plastic pillar cover
so you can hide the wires underneath. Then use the included 2-sided tape
to affix it to the outside of the pillar. Alternatively, you can use velcro (not
included) and affix it to the ceiling, just above the top of the A-pillar, as
most car ceilings are of a fuzzy material that velcro sticks to. Keep the An-
tenna Unit out of constant contact with sunlight (heat negatively affects RF
communication), and mount it as far as possible from metal parts.
19
Two connectors on back are for
firmware programming only.
1480/1460
Control
Module
Suggested Mounting Location
V I S I O N R F P A G I N G S Y S T E M U S E R ' S G U I D E
LED
Program
Switch
Shock
Sensor
"A" Pillar