Introduction; Description; Rmw821 Receiver - PROEL RMW821 User Manual

INTRODUCTION

Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.

DESCRIPTION

The RMW821 Wireless Microphone is a UHF, PLL controlled, true diversity system providing a reliable and
high quality signal transmission and equipped with automatic channel scan and IR sync.
RMW821 Wireless Microphone system features 3 units: RMW821 receiver, RMW8M handheld transmitter
and WM8B body pack transmitter. The system is available in two different configurations:
RMW821M: RMW821 + RMW8M
RMW821H: RMW821 + RMW8B + headset microphone
99 channel frequencies are available allowing the simultaneous use of 6 devices without interference
between them.

RMW821 RECEIVER

See FIG. 1 at page 27:
1. ANT 1 and ANT 2
These are the receiving antennas. Screw them in and raise them up during the use. In order to obtain a
good transmission angle them at 90° and place the receiver away from other metal objects and far away
no more than 50m from the transmitter. The internal diversity receiving circuit chooses the best signal
from one of the two antenna.
2. 12VDC IN
Socket for the AC/DC adaptor: use only the adaptor supplied with the system.
3. OUTPUT (BAL)
Balanced output with mic level: connect it through a XLR cable to a mixer MIC input. This output is used
preferably for long runs.
4. VOLUME
Volume potentiometer: set this control to a proper level that doesn't saturate the mixer input channel.
The volume control operates for both BAL and UNBAL OUTPUTS.
5. OUTPUT (UNBAL)
Unbalanced output with line level: connect it through a mono 6.3mm jack cable to a mixer or instrument
amplifier input. This output is used preferably for short runs.
6. OUTPUT LEVEL
This switch set the proper level for the UNBAL OUTPUT: set it as H if you are using a LINE input in the
mixer or set it as L if you are using a MIC input in the mixer.
7. POWER
On/off switch: press and hold for two seconds to switch on or off the receiver.
8. SET BUTTON
Pressing this button you can change the value of the correspondent menu option. After pressing it once,
the display shows the current value of the selected option (flashing): you can change the value using up
and down buttons or leave the value as it is. Press the SET button again to store the new value and the
receiver goes back to normal operation (see RMW821 MENU OPTION for detailed operations).
9. UP BUTTON
Pressing this button during the normal operation you can scroll between the menu options. After the SET
button is pressed, you can use this button to change the value of the option selected.
6