PROEL RMW821 User Manual page 9

press to confirm, or leaving "NO" will exit.
The receiver scrolls all the 99 channels to find a free one and selects the best. Please note that, if there
is another transmitter operative in the same place, its frequency channel is rejected: so for a correct
auto-search operation, when you have more than one RMW821 systems to set up, you must leave ON
any transmitter you have already set up and synced with its receiver, except the transmitter that you
want to set up, which must be off.
Lock
Select "Lock" to avoid any system's involuntary change:
To lock the receiver you have to press
display will show OFF, press
To unlock the receiver you have to press
press to confirm.
Tune
Select "Tune" to choose manually a reception frequency:
Press
The display will shows the last used frequency number flashing, press
decrease the frequency at a 25KHz step in the 821-832 and 863-865 MHz range, then press
to confirm, the display will show the new frequency and channel U indicates a user set up:
IR
Select "IR" to sync the transmitter frequency:
Press
The display will show "NO", then press
confirm, the display shows:
sensor of the transmitter to the IR sensor of the receiver, after that the transmitter frequency is synced.
Then the receiver display shows the RF signal.
If the syncing doesn't happen, at the end of the 10 seconds the display will show:
to choose ON then press
to select then press
to select then press
, try again or set the frequency on the transmitter manually.
to select then press
then pressing
and choose "YES" then press
, you have 10 seconds to expose the IR (infrared)
The
to confirm.
choose OFF and
to increase or
to
9