Installation - Electrolux EPI09LEIW User Manual

6.4. Anti-cold air function
In HEAT mode, the indoor fan will not
operate in order to prevent cold air from
blowing out if the indoor heat exchanger
does not reach a certain temperature in
one of the following situations:

when the heating operation starts;

when the defrosting operation is
finished;

when heating at low temperature.
6.5. Gentle breeze
The indoor unit may blow gentle breeze
and the horizontal louvre rotates to
acertain position in one of the following
situations:
Max. cooling
Min. cooling
Max. heating
Min. heating
6.7. Tip for energy saving

Do not overcool or overheat. Setting
the temperature at a moderate level
helps energy saving.

Cover windows with a blind or a
curtain. Blocking sunlight and air from
outdoor is favorable for cooling.

7. INSTALLATION

7.1. Installation notes

Not following the instructions can
cause personal injury and/or property
damage.

Not following the instructions can
cause the unit to fail.

Let the unit be installed by an
authorised service centre.

Let the unit be installed in compliance
with local and governmental
regulations.

Let the unit be installed according to
the instructions from this manual.
Indoor side (°C)
32
17
30
0

In HEAT mode, the compressor does
not start operation after switching on
the unit.

In HEAT mode, the temperature
reaches the set value and the
compressor has stopped operation for
1 minute.
6.6. Opetaring temperature
range
The operating temperature range for
cooling-only units is 0-50 ˚C. The
operating temperature range for heat-
pump units is -15-(+30)˚C.
Outdoor side (°C)
50
0
30
-15

Clean air filters every two weeks.
Clogged air filters lead to inefficient
operation and energy waste.
6.8. Tip for relative humidity

If the unit is operated in an area with
a relative humidity of more than 80%
for a long time, condensate may drip
from the indoor unit.

First contact an authorised service
centre before relocating an already
installed unit

Disconnect power before working on
the unit.

The mains plug must remain
accessible after installation.

Keep sufficient distance between the
interconnection cable and the
refrigerant circuit because the circuit
operating temperature is high.

The pipes connecting the indoor and
outdoor unit are not included in the
unit.
ENGLISH 14