Download  Print this page

Installing An Optional Card - Yamaha RIVAGE PM10 Systems Setup Manual

Digital mixing system.
Hide thumbs

Advertisement

Table of Contents

Installing an optional card

HY card installation
Install a TWINLANe network card into HY card slot 1 on
both the DSP engine and I/O rack. HY card slot 1 is used
exclusively for a TWINLANe network card.
Installing an HY card
1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that fasten the slot cover
to remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
3.
Align both edges of the HY card with the
guide rails inside the slot, and then insert the
card into the slot with the card installation
lever pressed down.
NOTE
For information on which cards support each slot, refer to
"Introducing the devices" on page 10.
32
RIVAGE PM10 System Setup Guide
Slot cover
Card
Push the card all the way into the slot so that the
connector at the end of the card is correctly inserted
into the connector inside the slot.
4.
Pull up the card installation lever to lock in the
card.
Make sure that the lever claw is securely locked under
the bottom part of the slot.
NOTE
If the lever claw does not lock in, pull up the card slightly,
then push it in.
5.
Affix the card using the screws that were
previously used to affix the slot cover.
If the card is not fastened securely, component failure
or malfunction may occur.

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: