Download  Print this page

Installing And Removing Optional Cards; Installing An Ry Card - Yamaha Rivage PM10 Owner's Manual

I/o rack rpio622.
Hide thumbs

Advertisement

Installing and Removing
Optional Cards

Installing an RY Card

1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that fasten the slot cover
to remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
Slot cover
3.
Align both edges of the card with the guide
rails inside the slot, and then insert the card
into the slot.
Push the card all the way into the slot so that the
connector at the end of the card is correctly inserted
into the connector inside the slot.
4.
Fasten the card using the screws attached to
the card.
If the card is not fastened securely, component failure
or malfunction may occur.
NOTE
Use a tool, such as a screwdriver, to tighten the screws
securely and affix the card.
The unit's card slots are designed so that all cards will be
installed without any gap between them to improve
shielding quality.
If the screws are tightened incorrectly or insufficiently, the
shielding quality will fall short. Also, you might have
difficulty in installing additional cards.
Card
RPio622 Owner's Manual
13

Advertisement

Table of Contents

   Related Manuals for Yamaha Rivage PM10

Comments to this Manuals

Symbols: 0
Latest comments: