How To Remove The View Finder Assembly - JVC GY-HM790U Service Manual

(4) Disconnect the wire from the connector
board.
(5) Remove the three screws (S4) attaching the handle as-
sembly.
(S4)
Handle assembly
(6) The handle assembly is easily removed by slightly sliding
to the direction of the arrow.
• When connecting the LED connector on EAR board,
ensure the polarity that the red wire should be con-
nected longer pin of the LED.
Longer pin
Red wire
1-12 (No.HC034<Rev.001>)
CN48 on the EAR
CN48
EAR Board
Fig.33
(S4)
Fig.34
EAR Board
Fig.35
3.6

HOW TO REMOVE THE VIEW FINDER ASSEMBLY

3.6.1 Removing the lens unit assembly (See figure 36, fig-
ure 37 and figure 38)
(1) Loosen the lock ring, then pull out the lens unit assembly.
Lock ring
(2) Insert a fine screwdriver into the hole on the back of the
slide cover. While keeping the fine screwdriver inserted,
turn the lens unit assembly to the direction of the arrow.
The lens unit assembly can be removed.
Hole
(3) When attaching the lens unit assembly, align the marks on
the slide cover and the lens unit assembly, then turn the
lens unit assembly to the direction of the arrow to lock.
Fig.36
Lens unit assembly
Fig.37
Marks
Fig.38