Table of Contents
Advertisement
(5) Remove the four screws G and the one screw H attaching
the case (HDD), then remove the case (HDD).
Screw G: Short
Screw H: Long
G
(6) Remove the one screw J and the one screw K attaching
the OPE unit.
Screw J: Short
Screw K: Long
(7) Pull out the wire from the connector
LOG board, then remove the OPE unit.
OPE Unit
K
CN204
ANALOG
Board
(8) Remove the six screws L and the one screw M attaching
the upper assembly.
Screw L: Short
Screw M: Long
(9) Pull out the wire from the connector
board, then remove the upper assembly.
• When attaching the upper assembly, be sure to set the
two tabs firmly.
Set the tabs firmly
Upper assembly
Set the tabs firmly
CN107
MAIN Board
L
L
1-6 (No.HC044<Rev.001>)
G
H
Case (HDD)
Fig.6
CN204
on the ANA-
J
Fig.7
CN107
on the MAIN
L
L
Fig.8
3.3
Removing the view finder assembly (See Figure 9, Fig-
ure 10, Figure 11)
(1) Remove the four screws A attaching the rear cover assem-
bly, then remove the rear cover assembly.
A
Rear cover
assembly
(2) Remove the one screw B attaching the REAR board.
(3) Pull out the wire from the connector
board, then remove the REAR board.
(4) Pull out the wire from the connector
LOG board.
(5) Remove the five screws C attaching the view finder assem-
bly, then remove the view finder assembly.
CN205
ANALOG Board
M
A
Fig.9
CN6001
on the MAIN
REAR Board
B
CN6001
MAIN Board
Fig.10
CN205
on the ANA-
C
View finder assembly
C
Fig.11
Advertisement
Table of Contents
