Taking A Reading; Changing Modes; Recalling Measurements In Memory; Replacing The Battery - MABIS 18-107-000 Instruction Manual

Taking a Reading

Wait 30 minutes to take tempearture after exercise, bathing or returning from
the outdoors.
NOTE: Many pediatricians recommend the use of ear ther-
mometers for children older than 6 months. Wait 30 minutes
1. Press and hold the SCAN button for one second, then
release. The system will perform a self-test, Fig 1.
2. After performing the self-test, the display will show
the last temperature taken, Fig. 2. The thermometer
will beep indicating that the unit is ready for
measurement.
3. Gently insert the probe snugly into the ear canal until a
slight resistance is felt. Press the SCAN button, Fig. 3,
and promptly release the button then you will hear a beep.
Pull probe out to read results.
4. If the measurement is below 100.4°F (38°C), the
thermometer will beep once and the measurement
will be shown on the display with a happy face
symbol, Fig. 4.
5. If the temperature is 100.4°F (38°C) or above, the
thermometer will sound one long beep followed by two
short beeps. The measurement will be shown on the
display with a sad face symbol to indicate fever, Fig. 5.
6. Thermometer will automatically beep and shut off after
approximately 1 minute of non-use.
NOTE: To ensure accuracy,
1. Please wait at least 10 seconds between successive readings.
2. Clean the probe lens before and after each use.
NOTE: The temperature reading is only for reference. Consult a physician
before taking any medical action.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
8

Changing Modes

Temperature readings can be displayed in either Fahrenheit
or Celsius. To switch between °F or °C, press and hold the
SCAN button. Without releasing, also press the ʻMʼ button
and toggle between the modes, Fig. 1 and 2.

Recalling Measurements in Memory

The last 10 measurements taken are automatically
stored into memory. To recall measurements, press
the SCAN button to turn the unit on. After the unit
beeps, press the ʻMʼ button to view measurements in
memory. Continue to press the ʻMʼ button to view the
next previously stored measurement, Fig. 1. The unit
will beep each time a recorded measurement is viewed.
The thermometer will automatically shut off after one
minute of non-use

Replacing the Battery

Your Instant Ear Thermometer requires one lithium battery, type CR2032.
The battery should be replaced when the low battery symbol appears on the
display, however, the thermometer will still work if the
battery is not replaced immediately.
To replace the battery:
1) Slide the battery cover off.
2) Using a non-metal pointed tool, carefully remove the
battery and insert the new battery with the positive (+)
side facing up.
3) Replace the battery cover.
NOTE: Properly dispose of the batteries at appropriate collection sites according
to national and/or state regulations
Memory
Index
Symbol
9
Fig. 1
Fig. 2
Fig. 1