Advertisement
4. Replacement of rubber tire and wheel complete
(1) Pull out wheel complete by removing hex. socket
bolt that secures the wheel complete.
(2) Check that there is no abnormalities in the gear
section of the wheel complete on the drive side.
If broken teeth or abnormal wear is found, replace
the gear with a new one. (Driven gear can be
used for drive gear.)
(3) Remove rubber tire from the wheel complete.
(4) Wipe oil or dirt off the peripherals of the wheel
complete, replace new rubber tire.
At this time mate convex of the wheel complete
and the groove of the rubber tire mutually.
(5) Remove dirt on the shaft and on the metal gear
section.
(6) Replenish grease to the drive side gear. (Makita
grease G No.2) In the case of a new gear, coat
about 16g grease on the whole of the gear.
(7) Replenishi oil to the shaft and assemble washer,
wheel complete and washer in a row and fix them
with a hex. socket bolt.
Convex
Groove
Rubber tire
Hex. socket bolt M6x12
Flat washer 16
Wheel complete
Rubber tire
Flat washer 16
Shaft
(frame or slide plate)
Wheel complete
Gear section
Advertisement
