Rorke Data Galaxy 16i User Manual page 40

install SATA-to-SATA MUX kits that enable users to install SATA
hard drives into their redundant subsystem The MUX kits must all
be purchased separately.
1. Installation:- The MUX kit is mounted onto a metal base plate
that has three pre-drilled holes reserved for retention screws
2. Three corresponding pre-drilled screw holes can be found at
the back of the drive tray shown in Figure 2- 6.
Mounting Screw
locations
Figure 2- 6: Empty Drive Tray
3. Place the MUX kit at the back of the drive tray. Hold the
MUX kit in place and turn the drive tray over. Align the holes
in the base of the drive tray with the holes in the MUX kit base
tray.
4. Insert the three available retention screws from the bottom of
the drive tray. These screws will firmly secure the MUX kit to
the drive tray and facilitate the installation of the appropriate
drive.
2-12 Galaxy 16i User's Manual