Table of Contents
Advertisement
Figure 5- 1: Removing the PSU Retention Screw
4. A clip can be seen at the top left-hand corner of the PSU.
This clip is used to secure the PSU into the subsystem
enclosure. To remove the PSU, push this clip towards the
right. (See Figure 5- 2).
Figure 5- 2: Dislodging the PSU
5. After the PSU module has been dislodged from the enclosure,
use the handle at the rear of the PSU to gently pull the PSU
module out of the enclosure. (See Figure 5- 3)
Figure 5- 3: Removing the PSU from the subsystem
5-6
Push Clip to the right
Gently pull the PSU out the
enclosure using the handle
Galaxy 16i User's Manual
Advertisement
Table of Contents
