Yamaha RIVAGE PM10 Systems Setup Manual page 22

Channel Strip section (Bay L, Bay R, Bay C)
1
2
3
4
5
7
8
9
)
!
@
#
22 RIVAGE PM10 System Setup Guide
1 Screen encoder (Bay L and C only)
2 Channel strip encoder
3 [Fn] key
6
4 [SEL] key
5 Meter LEDs
6 Dynamics LEDs
7 [ON] key
8 Channel name display
9 Channel color indicator
$
Controls the knob currently selected on the touch
screen. The knob function varies depending on the
screen currently displayed.
Adjusts the gain, pan, and the other parameters of the
channel. You can assign five parameter functions
(selected from the following list) to this encoder, and
use the [UP]/[DOWN] keys to select the function.
• PAN/BALANCE
• ANALOG GAIN
• DIGITAL GAIN
• MIX1 SEND - MIX72 SEND
• MATRIX1 SEND - MATRIX36 SEND
• HPF FREQUENCY
• LPF FREQUENCY
• DYNAMICS1 THRESHOLD
• DYNAMICS2 THRESHOLD
Executes the function as assigned by the user. You
can assign one of the following functions:
• INPUT A/B
• ISOLATE
• ALTERNATE CUE
• ENCODER PARAM
Enables you to select the channel that will be
controlled in the Channel Strip section or on the
display. When the channel is selected, the key LED
will light.
Indicate the channel level.
Indicate the status of Dynamics 1 and 2.
Switches the channel on or off. If the channel is on,
the key LED will light. In SENDS ON FADER mode,
this key works as an on/off switch for signals sent
from each channel to the currently-selected MIX/
MATRIX bus.
Indicates the channel name, fader value, etc.
Indicates the channel color. You can select the
channel color from nine options including OFF.