Oil Filter - PIAGGIO BEVERLY Cruiser 250ie Service Station Manual

Maintenance
Check
This operation must be carried out with the engine
cold and following the procedure below:
1. Place the vehicle on its centre stand and on
flat ground.
2. Undo cap/dipstick "A", dry it off with a clean
cloth and replace it, screwing down com-
pletely.
3. Remove the cap/dipstick again and check
that the level is between the min and max.
marks; top up if necessary.
The MAX level mark indicates a quantity of around
1300 cc of engine oil. If the check is carried out
after the vehicle has been used, and therefore with
a hot engine, the level line will be lower; in order
to carry out a correct check it is necessary to wait
at least 10 minutes after the engine has been stop-
ped, so as to get the correct level.
Oil top up
The oil should be topped up after having checked the level and in any case by adding oil without ever
exceeding the MAX. level.
Restoration of the level from MIN to MAX requires approximately 200 cc.
Engine oil filter
The cartridge filter must be replaced every time the oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and oil drainage plug, screwing them up to the specified torque. Refit the new cartridge filter
being careful to lubricate the O-ring before the fitting. Change the engine oil.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the requirements of API SL, ACEA A3, JASO MA specifications
MAIN - 10
BEVERLY Cruiser 250ie