Electrical system
•
If the twin-filament bulb is in working order
•
If fuses No. 5 are in working order
•
If the light switch is in working order when in HIGH and LOW modes
•
If the light remote controls are in working order
With the main switch in position "ON", check:
•
If there is voltage on the red-green cable of the light switch
•
If there is voltage on the grey cable of the light remote controls
•
The switch wiring harness and the contacts of the light socket
Fuses
Remote control switches
The electrical system has six remote control
switches, five of which are under the front shield,
and the other under the scooter right fairing.
Remove the front shield in order to get access to
the five remote control switches on the scooter
front section.
In order to access the remote control switch at the
rear of the scooter, it is necessary to remove the
right side fairing.
A= Electric fan remote control
B= Saddle opening remote control
C= Low-beam light remote control
D= High-beam light remote control
E= Injection load remote control
F= Start-up remote control
The electrical system is equipped with:
1. Six protective fuses "A" located inside the side panel on the right-hand side;
2. Four protective fuses "B" located inside the compartment on the upper left-hand side.
The chart shows the position and characteristics of the fuses in the vehicle.
ELE SYS - 28
BEVERLY Cruiser 250ie