Oil Bleed Screw - PIAGGIO BEVERLY Cruiser 250ie Service Station Manual

Braking system
- Remove the internal parts from the floating body
with short blasts of compressed air through the
brake liquid pipe to facilitate expelling the plung-
ers.
- Check:
•
that the plates and the body are whole
and in good condition;
•
that the cylinders of the calliper floating
body do not show signs of scratches or
erosion, otherwise replace the entire
calliper:
•
that the guides of the fixed plate are not
scratched or eroded, otherwise re-
place the entire plate;
•
that the brake pad check spring works
properly
CAUTION
ALL THE SEALS AND GASKETS MUST BE RE-
PLACED EVERY TIME THE PUMP IS SERV-
ICED.
Refitting
- Fix the brake calliper support plate to the crank-
case and the brake calliper to the bracket, tight-
ening the screws to the prescribed torque.
- Apply the recommended product to the fixing
screws of the brake calliper to the bracket.
- Bleed the system.
N.B.
WHILE REFITTING, REPLACE THE COPPER
GASKETS ON THEIR FITTINGS.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Oil bleed screw 12 - 16 Screw tightening cal-
liper to the support 23 ÷ 25 Screw fixing rear
brake calliper support to engine 20 ÷ 25 Brake
fluid hose-calliper fitting 16 ÷ 20
See also
BRAK SYS - 4
BEVERLY Cruiser 250ie