Hardware Panels; Chapter 3 Hardware Panels; Front Panel; Gigabit Ethernet Ports - ZyXEL Communications XS1920 Series User Manual

This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.

3.1 Front Panel

The following figures show the front panel of the Switch. See
on the LEDs. The reset button is also located here as circled below. See
more information on using that.
Figure 7 Front Panel: XS1920-12
The following table describes the ports.
Table 2 Panel Connections
CONNECTOR
Ports 1-10
Ports 11-12
Ethernet
Ports 11-12 Fiber

3.1.1 Gigabit Ethernet Ports

Ports 1-10 on the Switch are 100Mbps/1Gbps/10Gbps auto-negotiating, auto-crossover Ethernet
ports with full duplex support.
An auto-negotiating port can detect and adjust to the optimum Ethernet speed of the connected
device. Auto-1000M / Full-Duplex supports Ethernet and fiber connections at 100Mbps or
100Mbps/1Gbps/10Gbps
Ethernet Ports
DESCRIPTION
These are 100Mbps/1Gbps/10Gbps RJ-45 Ethernet ports.
Connect these ports to a computer, a hub, an Ethernet switch or router.
These are 100Mbps/1Gbps/10Gbps RJ-45 combo uplink ports. The fiber port connection
takes priority if the corresponding Ethernet uplink port is also connected.
Connect these ports to high-bandwidth backbone network Ethernet switches using 100/
1000/10G Base-T cables.
These are SFP / SFP+ uplink Slots Use SFP transceivers in these slots for fiber-optic to
backbone Ethernet switches.
XS1920 Series User's Guide
26
C
H A PT ER

Hardware Panels

Section 3.3 on page 30
Section 3.4 on page 30
Ethernet/SFP(+)
Uplink Ports/Slots
3
for information
for