Trouble Shooting - Hayter Envoy 36 Electric Instruction Manual

TROUBLE SHOOTING

PROBLEM CAUSES
Motor fails to start
Mains supply socket dead
RCCB tripped
Plug pulled out of mains socket
Fuse failure
Supply cable damaged
Cutterblade obstructed
Motor will not stop Faulty switch control unit
Cutterblade runs
Faulty brake unit
on excessively after
switching 'OFF'
Motor vibrates
Mounting bolt loose
excessively
Cutterblade bolt loose
Cutterblade out of balance
Uneven cut Undulating ground contours
Cutterblade worn
Cutterblade out of balance
Wheels/roller damaged
CORRECTIVE ACTION
Test socket by plugging in another
appliance
Remove mower plug and check
RCCB action. Check the supply
cable for any obvious signs of
damage and replace immediately
if defective.
Re engage plug
Fit a new amp fuse
Disconnect from the mains and
check the supply cable for any
obvious signs of damage. Replace
immediately if defective
Disconnect from the mains and
remove any obstruction
Ensure that the switch lever has
returned to the 'OFF' position.
Disconnect from the mains and
contact your Hayter dealer
Contact your Hayter dealer
Tighten bolts
Tighten bolt
Balance cutterblade
Change direction of travel
Sharpen the cutterblade
Balance cutterblade
Inspect and replace as necessary
13
PROBLEM CAUSES
Discharge chute
Grass is wet
blocks
Cut height too low
Grassbag full
No airflow through the grassbag
Mower is hard to Cut height too low
push
Wheels/roller damaged
Poor grass condition No airflow through the grassbag
Discharge chute blocked
Wet grass
Grassbag full
CORRECTIVE ACTION
Mow dry grass
Increase cut height
Empty grassbag
Clean the grassbag
Increase cut height
Inspect and lubricate or replace as
necessary
Clean the grassbag
Remove blockage
Mow dry grass
Empty grassbag