Cutterblade Sharpening; Supply Cable; Storage - Hayter Envoy 36 Electric Instruction Manual

MAINTENANCE SCHEDULE / MOWER MAINTENANCE

Cutterblade Sharpening

A slightly worn cutterblade may be re-sharpened. Both blade
edges must be sharpened equally to ensure balance. Sharpen
the cutterblade every 25 mowing hours or more frequently if
conditions require. Remove the cutterblade from the mower and
clean using a brush and water.
Inspect the cutterblade for signs of damage.
Sharpen both cutting edges with a flat file to restore performance.
(Refer fig.18)
Ensure that the cutterblade is balanced. Use a screw driver with
a round shaft to support the cutterblade through its centre hole.
Hold the cutterblade horizontal and then release. A balanced
cutterblade will remain horizontal. (Refer fig.19)
If the cutterblade is not balanced the heavy end will rotate
downwards. Sharpen the heavy end until the cutterblade is
correctly balanced. (Refer fig.20)

Supply Cable

Check the condition of the supply cable for damage or ageing.
Replace immediately if defective.

Storage

To collapse the handlebar, first unscrew the two top securing
Fig. 18 Fig. 19
30-45
knobs to allow the top section of the handlebar to pivot forward
to rest against the middle section. Unscrew the bottom two
securing knobs sufficiently to allow both top and middle sections
to be folded forwards.
To ensure that your mower is maintained in good working order,
it is important that the following procedure is adopted when the
mower is stored for periods in excess of one month. Refer to the
'Maintenance' section as necessary.
Clean all areas of the mower and ensure that the grassbag is
clean.
Lubricate the mower.
Treat metal parts with a water repellant anti-corrosion product.
Lower the handlebar if desired.
Cover the mower with a protective sheet and store in a dry area.
Rest the mower deck on wooden blocks to remove the weight of
the mower from its wheels/roller.(Refer fig.21)
CAUTION - PREVENT ENVIRONMENTAL DAMAGE.
(Refer fig.22)
EU Directive 2002/96/EC classifies this product as an electrical or
electronic equipment.
Fig. 20 Fig. 21
(a) These products should not be disposed of as unsorted municipal
waste. (Refer fig.22)
(b) They should be taken to a designated collection point or
recycling centre and handled according to national laws in the
area.
(c) The consumer has a critical role in returning waste electronic/
electrical equipment for recycling and disposal.
(d) Recycling keeps these products out of the municipal waste
stream.
(e) The crossed-out bin symbol is a reminder to follow these
points.
(f) Please contact your local authority or local dealer and ask for
further details regarding the correct method of disposal.
Fig. 22
11