Setting Job During Warmup - Oce variolink 9522 User Manual

Before Making Copies
8.4

Setting Job During Warmup

While the machine is warming up after power is turned on, you can select
copy conditions and start scanning so that the machine may start printing
immediately the machine engine is ready.
Service can set the machine to disable this function. Contact your service
representative, if desired.
To scan the original during warmup
1
Turn on the main power switch and sub power switch of the machine.
– For details on turning on the power, see page 2-25.
2
Display the Copy Screen to check that the message "Ready to set re-
serve job" is displayed in the message area.
– A few seconds after the Wake-up Screen appears on the touch
panel, the Machine Status Screen will be displayed.
Touch [COPY] tab to change the Machine Status Screen to display
the Copy Screen, then check that the message "Ready to set re-
serve job" is displayed in the message area.
3
Set the desired copy conditions, and enter the print quantity.
– For details on setting print quantity, see page 8-13.
4
Position the original FACE UP in the ADF or FACE DOWN on the orig-
inal glass.
– For details on positioning the original, see page 8-8.
5
Press [Start].
– When scanning the original for the job is started, a popup menu will
appear on the Copy Screen.
VarioLink 9522
8
8-15