Contents Of Package; Cleaning And Maintenance; Placing The Telephone; Installation Of The Telephone - elmeg CS290 User Manual

Contents of package

System telephone, handset with handset connecting cord, ISDN connection cord (ap-
prox. 3m), 2 feet, 1 set of operating instructions (German, English, French and Italian), la-
bel panel for programmable function keys.

Cleaning and maintenance

The ISDN system telephone has been manufactured for normal, everyday use. When re-
quired, clean the device with a slightly moistened cloth, or with an anti-static cloth. Never
use a solvent to clean the phone. Never use a dry cloth; electrostatic charges could re-
sult in faults or malfunctions in the electronics. It is essential that no liquids penetrate into
the inside of the telephone, as this could destroy the phone.

Placing the telephone

Before installing the telephone you must mount the rear feet for the unit at the positions
(6) shown in figure 3. Depending on the height of these two feet you can adjust the dis-
play angle of your phone to your personal angle of vision. Ensure that the two feet have
the same height.
To adjust the height, pull the feet off of the bottom of the telephone, rotate them around
60° and place them back in the enclosure. By turning the feet by around 60° (around the
longitudinal axis) each time you can set three different heights for the phone.
Please note that the plastic feet of your telephone may leave marks on sensitive surfa-
ces, such as furniture. The manufacturer of the ISDN system telephone is not liable for
any such damage. Therefore, use appropriate non-skidding pads under the phone.

Installation of the telephone

Connecting the handset connecting cord
Connect the connecting cable (1) as shown in figure 1. After this, place and secure the
cord in the cord groove (4) and lock it below the two cord retainers (5).
Connecting the ISDN cord
Connect the ISDN cord (2) as shown in figure 1 (So jack). Ensure that the longer ISDN
connector is plugged into the ISDN jack and the shorter ISDN connector into the ISDN
socket on the telephone. After this, place and secure the ISDN cord in the cord groove
(4) and lock it below the two cord retainers (5).
2