Auto Return; Home Position; Tilt Limit - LG LW9228 Series Owner's Manual

Compass
You can display the north, south, east and west information
on the screen.
1. Select [COMPASS] option on the [SPECIAL] menu.
2. Set the [COMPASS] option to [SET] and then press
button.
3. Select north point using the PTZ control buttons and
then press button.
4. Set the [COMPASS] option to [ON].

Home position

The home position is the camera's basic position.
The camera returns to this position whenever you want.
Use the following procedure to make the home position.
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use or button to set it ON.
3. Press button.
4. Select [SET] option and then press
5. Select the home position where you want and then
press button.
6. Select [DWELL TIME] option and then select the dwell
time.
7. Select [RETURN] option and press
setting menu.
» Go to Home position
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use or button to set it ON.
3. Press button.
4. Select [GO] option and then press
camera will move to the home position.
NOTE
• If you do not want to use the home position
function, set the [HOME POSITION] option to [OFF].
• If you set the [HOME POSITION] to [ON], the [AUTO
RETURN] option is set to [OFF] automatically and you
can not use it.

Auto return

This function can be used to specify automatic return to a
particular mode if a certain amount of time elapses without
any operation being performed.
1. Select [AUTO RETURN] option on the [SPECIAL] menu.
2. Use
3. Select [RETURN TIME] option and then select the auto
4. Select [RETURN] option and press
If you set [AUTO RETURN] to [ON], the [HOME POSITION]
option is set to [OFF] automatically and you can not use
it.

Tilt limit

button.
You can specify the tilt range. If you set this function, the
camera is able to tilt from 15 º to 165 º .
1. Select [TILT LIMIT] option on the [SPECIAL] menu.
2. Use
button to exit the
button. The
or button to set it [ON] and then press
button.
return time.
setting menu.
NOTE
or button to set it [ON]. If you do not want to
use this function, set it to [OFF].
Operation and settings
button to exit the
51
4