Initial Operation - Bosch ISIO Original Instructions Manual

OBJ_BUCH-904-001.book Page 22 Monday, December 22, 2008 11:20 AM
22 | English
Assembly
For Your Safety
Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Battery Charging (see figure A)
Do not use other battery chargers. The sup-
plied battery charger is designed for the Lith-
ium-Ion battery in your garden product.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The "Electronic Cell Protection (ECP)" protects
the lithium ion battery against deep discharging.
When the battery is run down or discharged, the
garden product is shut off by means of a protec-
tive circuit: The blade no longer moves.
Do not continue to press the
WARNING
On/Off switch after the garden
product has been automatically switched off.
The battery can be damaged.
Plug the mains plug of the battery charger into a
socket outlet and the charger plug 14 into the
socket 13 on the rear side of the handle.
The charging procedure starts as soon as the
main plug of the battery charger is inserted into
the socket.
The battery charge-control indicator 2 indicates
the charging progress. During the charging proc-
ess, the indicator flashes green. When the bat-
tery charge-control indicator 2 lights up green
continuously, the battery is fully charged.
F 016 L70 578 | (22.12.08)
During the charging procedure, the handle of
the garden product warms up. This is normal.
Disconnect the battery charger from the mains
supply when not using it for longer periods.
The garden product cannot be used during the
charge procedure; it is not defective when inop-
erative during the charging procedure.
Protect the battery charger against moisture!
Telescopic Handle (accessory or supplied
with "Grass Shear, Telescopic Handle")
The telescopic handle is designed only for
use with the grass shear at ground level.
Do not use the telescopic handle with the
shrub shear or above ground level.
Removing Telescopic Handle
Unplug the handle connector 10.
To release the garden product from wheel
cart 12, pull the garden product in the direc-
tion shown.
Fitting Telescopic Handle (grass shear only)
Align the grooves on the garden product with
fixing on the wheel cart 12.
Plug in the handle connector 10.
Adjusting Handle Length
Loosen the adjustment collar 9.
Pull the telescopic pipe 8 out to increase the
height, or push it in to decrease the height.
Re-tighten adjustment collar 9.
Adjusting for Edging Mode
Turn the garden product 90 °, in either direction
to position the garden product in the vertical
edging mode.
Operation

Initial Operation

Switching On
Press the lock-off button 6 and hold while actu-
ating the On/Off switch 5.
Release the lock-off button 6 again.
B
C
D
Bosch Power Tools