Listening To Audio With Bluetooth Headphones - Sony STR-DN1070 Operating Instructions Manual

Listening to Audio with
BLUETOOTH Headphones
1
Press RX/TX repeatedly to
select "BT TX".
The BLUETOOTH mode of the receiver
switches to transmitter.
2
Turn on the headphones and
set them to pairing mode.
3
Hold down CONNECTION
PAIRING BLUETOOTH on the
receiver for about 2 seconds.
"SEARCHING" flashes on the display
panel for about 10 seconds, and then the
name of detected BLUETOOTH device
appears.
CONNECTION
BLUETOOTH
* XXXXXX represents the name of a detected
BLUETOOTH device.
GB
44
PAIRING
4
Press / to select the name of
the headphones, and then
press .
After "CONNECTING" flashes and the
headphone name is displayed,
BLUETOOTH connection is complete.
* XXXXXX represents the name of a detected
BLUETOOTH device.
5
Press one of the input buttons
to select the input you want.
The sound is output from the
BLUETOOTH headphones. No sound is
output from the receiver.
6
Adjust the volume of the
BLUETOOTH headphones.
Volume control on the receiver and
remote control only works for the
BLUETOOTH headphones.
Note

The most recently connected BLUETOOTH device
can be reconnected simply by performing step 1
above.

The one-touch connection (NFC) cannot be used in
TX (transmitter) mode.

When "NOT. USE" appears on the display panel,
you cannot switch BLUETOOTH mode. Check the
following:
 BLUETOOTH function is in use
 Screen mirroring function is in use
 [Bluetooth Mode] is set to [Off]