ADC Ultra-8/16 Operator's Manual page 24

Assuming the status message we received was "Area A alarm is Armed" If we press
the "*" key, Area "A" will be Disarmed and we would receive a status message "Area A
alarm is Disarmed" (or whatever message is programmed by the installer)
While you are on-line with the panel you can move between menu options by entering
the code of the option you want to control. Assuming there was a code of "4321"
programmed to control outputs. After having used code "2045" to control the Arm/Disarm
status of Area A, we first press the "#" button to reset all previous entries. Then we can
enter the digits "43215" (that is "4321" as the code to control outputs and "5" to select
output #5). The current status of output #5 will be given either by the voice message or
the appropriate tone and then the status can be changed with the "*" button on the
remote telephone (Note; For output control you must enter in the 4 digit code e.g. 4321
followed by the output number you wish to control, in this case 5).
At any stage, if you enter in an incorrec t code you can press the "#" button on the remote
telephone to clear all code entries and then start again.
To turn on the optional Microphone (only available if the Voice Board is fitted) you must
enter in the appropriate code followed by the "*" button. To turn the Microphone off you
simply press the "*" button again.
To end a Command Control session simply hangs up the phone. The panel is
monitoring the line at all times and 15 seconds after the last key press it will
automatically hang up the line. This 15-second timer is active during the whole
command control process so a period of 15 seconds without a key press will cause the
panel to hang-up.
24