How To Arm Partitions - ADC Ultra-8/16 Operator's Manual

How to Arm Partitions

The protected area can be grouped into 4 separate partitions (A, B, C, D). The system
can be grouped for User 's convenience to separate, in a business environment, the
offices from the warehouse area, or in a private residence, the different rooms of the
home, e.g., living room, bedroom, etc.
To arm partition A enter user code for partition A
To arm partition B enter user code for partition B
To arm partition C enter user code for partition C
To arm partition D enter user code for partition D
Note: to arming partition with code see page 9 "How to arm the system before exit"
During exit delay you can leave premises. At the end of the procedure, the ARMED
indicator lights up to indicate that the system is armed, and the system message is
displayed
(The indicators may go out after a few seconds, depending on the installer's setting).
To disarm partition, see "Disarming the System".
If enabled by the installer,
to arm the partition A, press <A> for 2 seconds.
To arm partition B, press <B > for 2 seconds
The same procedure is also applicable to partition B.
During exit delay you can leave premises. At the end of the procedure the ARMED
indicator lights up to indicate that the system is armed and system message is displayed.
(The indicators may go out after a few seconds, depending on the installer's setting).
Areas Disarmed
A - - -
Areas Armed
A - - -
Areas Exiting
- B
Areas Armed
- B
13