How To Display Events From Memory; How To Control Outputs And Devices; How To Get Into To User Program/Client Mode - ADC Ultra-8/16 Operator's Manual

How to Display Events from Memory

The system memory stores the last events. Press <MEMORY> to display list of events
Following the display of current system alarms the panel will then sequence through
the 255 historical memory events starting at the most recent event.
The system will display the last event and automatically scroll to the next one every 2.5
seconds, and a beep is emitted. Use the arrow keys to scroll up manually.
Wait until all messages are displayed, or press <ENTER> to cancel memory readout.

How to Control Outputs and Devices

The keypad enables control of external devices, such as an air-conditioner or heater.
To activate or halt a device, press <CONTROL> for 2 seconds and the number of the
device. Up to 8 different devices can be controlled via the keypad.
When you enter control mode the system prompts you to enter device # and then
<ENTER> to activate or deactivate the selected device.
How Local command control works
If a command control code for outputs is programmed and the output/s are allowed to be
locally controlled from the keypad, then entering the 4 digit code at a keypad will now
indicate the output status e.g. if output 1 is on
And the number of the device. Up to 8 different devices can be controlled via the
keypad.
When you enter control mode the system prompts you to enter device # and then
<ENTER> to activate or deactivate the selected device.

How to Get into to User Program/Client Mode

There are 2 levels of program mode, CLIENT mode and INSTALLER mode. Normally
the installer will give you access to the CLIENT mode so you can add, delete, or change
the user codes. If you request it your installer can provide you with access to the
INSTALLER mode as well. To get into CLIENT mode provided the system is NOT armed
Control Mode
- - - 4 - - - -
Control Mode
1 - - - - - - -
17
.