How To Adjust Buzzer Tone - ADC Ultra-8/16 Operator's Manual

To decrease LCD backlight, hold <CONTROL> and press <BYPASS> repeatedly until
the light goes off.
To increase keyboard backlight, hold <CONTROL> and press <MEM> repeatedly until
the light is increased to its maximum.
To decrease keyboard backlight, hold <CONTROL> and press < > repeatedly until the
light goes off.

How to Adjust Buzzer Tone

The User can adjust the volume of the buzzer tone can be adjusted, in 16 steps, from
fully On to Off.
To increase the volume, hold <CONTROL> and press <A> repeatedly until it is
increased to its maximum.
To decrease the volume, hold <CONTROL> and press <B> repeatedly until it is
decreased to off.
How Remote command control works
Another powerful feature available from your alarm is Command Control. This feature is
a remote control facility which allows valid users to access the panel via a standard
touch tone telephone and check or change the Arm/Disarm status of each of the areas,
operate each of the eight outputs or turn on an optional Microphone.
To perform any of the Command Control features you must first ring the phone number,
which the panel is connected to. The panel may be set up to answer after a specific
number of rings of it may be set-up to use a fax defeat option. Either way, when you ring
the phone number and the panel answers the call, the first thing you will hear over the
phone is a burst of modem tone for two seconds. After this tone has stopped you must
enter the access code, which is associated with the Command menu option you wish to
access. Remember, the code you enter will determine which menu option you access.
If you miss the pause, the panel will repeat the modem tone and then again pause for 5
seconds looking for your access code. This process will be repeated 4 times before
hanging up if no valid code is received. When entering codes or other information in
Command Control the "#" key acts as a "Clear" button.
When you have entered the required 4-digit access code the panel will reply with the
status message associated with the Command Control function you have accessed. For
example, lets say we have a code of "2045" to allow Arming & Disarming of Area A.
Once the code "2045" has been received the panel checks the current status of Area A
and replies with the pre-programmed voice message relating to that status e.g. if Area A
is Armed then the Armed message will be sent, if Disarmed then the Disarmed message
will be sent. If only the DTMF board is fitted, the voice message is substituted with a long
beep if Area A is Armed, and three short beeps if it is disarmed.
Once the status message has informed you of the actual state, you can use the "*" key
to toggle the option on & off or Arm and Disarm, e.g. in our example above, code "2045"
accesses Area "A" arming or disarming.
23