How To Bypass Zones; How To Use Chime (If Enable By Installer) - ADC Ultra-8/16 Operator's Manual

To disarm partition, see "Disarming the System".
Note: to arming partition with code see page 9 "How to arm the system before exit"

How to Bypass Zones

Bypass any zone that cannot be closed. You can bypass selected zones prior to arming.
It is also used to temporarily exclude a faulty zone from service, which requires repair.
To bypass a selected zone, press <BYPASS>, Bypass indicator lights up to indicate that
the system is in bypass mode.
Enter the zone number (e.g. 01, 05, 12, 47) one or more zones.
Following press <ENTER>, the system displays the bypassed zones.
While in the Bypass mode it is possible to bypass more than one zone, press
<BYPASS>, Bypass indicator lights up to indicate that the system is in bypass mode,
Add the zone number (e.g. 03) one or more zones, following press <ENTER>, the
Bypass indicator lights up to indicate zone(s) bypassed.
To un-bypass zones, press <BYPASS>, enter zone number (e.g.05,12) and press
<ENTER>.
Note: Disarming automatically un-bypasses all zones.

How to use Chime (If enable by Installer)

A Chime (Day zone) is a detector that can be part armed while you are at home but
working in another part of the building. It can be programmed to operate a buzzer or light
to let you know you have a visitor.
To disable this function, press <CHIME> for 2 seconds, as shown below.
To enable this function, press <CHIME> for 2 seconds, as shown below.
Bypass Zones
01 05 12
Zone 1 Bypass
Zone 1
Chime OFF
Chime ON
14