How To Add Or Change User Code; How To Add Or Change Telephone Numbers - ADC Ultra-8/16 Operator's Manual

new code will be flashed to you and 3 short beeps to indicate correct entry or 1 l o ng
beep if not accepted. Press <PROG> and <ENTER> exit user Code Program mode.
Press <PROG> enter Master code and <ENTER>. The display will show "Client Mode".

How to Add or Change User Code

While in CLIENT mode, press <PROG> and the User number (2 to 99) to add or
change the code. Use the numeric keyboard to enter the new code. The code can hold
any combination of 1 to 6 digits. Press <ENTER> to save your new code.
Repeat the procedure for all users or use arrow (MEM) key to advance to next user.
Press <PROG> and <ENTER> to exit Local Program mode.
How to Delete User Code
While in CLIENT mode, press <PROG> and the User number (2 to 99) you intend to
delete. The display shows the code.
Press <CONTROL> and<0> simultaneously to delete User code. Press <ENTER> to
save the change.
Press <PROG> and <ENTER> exit Client Program mode.

How to Add or Change Telephone Numbers

Your panel will accept up to 6 phone numbers with a total of 16 digits. Your panel can be
can be programmed to dial all or any of these depending on the event which has
occurred.(The six phone numbers are at program address 691 through to 696).
While in CLIENT mode, key in the following sequence <PROGRAM> <691> <ENTER>
(The address for telephone number 1), The existing number will be flashed out at the
Keypad then enter <NEW TELEPHONE #> <ENTER> The new numbers will be flashed
back to confirm acceptance.
Client Mode
User 3 Code
56789
User 8 Code
8765
19