Nexo PS 8 User Manual page 37

PS S
Procedure
Vertical
•
12mm diameter screws (not provided) are required to secure the wall suspension plate on the
wal;
•
Remove the 2 rear TORX screws holding connector plates on both sides of PS10R2 or PS15R2;
•
Fill each screw hole with Locktite 243 or equivalent;
•
Connect the suspension plate to the connector plate by using the srews provided with the VNI-
WS kit;
•
Position the srews in the oblong hole so that required vertical angle is obtained;
•
Secure the screws;
•
Suspend and secure the cabinet to the wall suspension;
•
Adjust horizontal angle.
WALL SUSPENSION PROCEDURE FOR VERTICAL INSTALLATION
ERIES HARDWARE SETUP PROCEDURE
Page 37/82