Table of Contents
Advertisement
NTI KEEMUX Series PS/2 KVM Switch
HOW TO DISABLE OPERATING MODES
The operating modes of the KEEMUX can be disabled if a user desires to do so.
which would also disable the Scan and Broadcast Modes, or, the Scan and/or Broadcast Modes can be individually disabled
leaving the other features in Command Mode enabled.
To disable these operating modes, the user must get access to the jumper block.
switches on the circuit board the keyboards plug into (called the digital board) inside the KEEMUX. (See Fig. 16.)
Rear Panel
Disconnect video
ribbons here
LED Board
Front Panel
Overhead view of video board on top of digital board.
If the unit is a rackmount style, the digital board is located directly beneath the cover of the unit, requiring the user to only remove
the 10 screws from the cover to get access.
instructions under "CONFIGURING THE JUMPER BLOCK" on page 22 to disable the desired mode(s).
If the unit is in a plastic case, the digital board is located on the bottom of the case, requiring the user to partially disassemble the
unit to gain access to the jumper block.
For models KEEMUX-Px in a plastic case:
1. Make sure the KEEMUX is completely disconnected from all CPU components.
the electrical outlet.
2. Remove the two philips-head screws from the underside of the KEEMUX and set the KEEMUX on a firm and flat
surface, bottom down. (See Fig. 17.)
3. Remove the top half of the plastic case from the KEEMUX.
15HD Connector
Video Board
Digital Board
The jumper block is located
below the LED board.
Figure 16- Location of the jumper block
With the cover removed, the jumper block will be easy to locate. Follow the
Philips-head screws
holding the plastic case
together
View of bottom of plastic case
Figure 17- Remove screws to open case
21
The Command Mode can be disabled
This block is located close to the dip-
Closeup view of jumper block on digital board.
JUMPER BLOCK
DIP SWITCHES
S
B
K
L
C
R
C
C
A
D
M
D
N
C
D
E
Be sure to unplug the KEEMUX from
Advertisement
Table of Contents
